OpenFlows | Water Infrastructure Forum Adding Shapefile of Community in Watergems

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Adding Shapefile of Community in Watergems

Offline Anan over 7 years ago

Respected Sir,

I am building a new HMS of our water network through model builder tool in watergems , I have added Transmisson, Distribution Pipelines. For the ease to allocate demand to junction/nodes i am going to import shapefile of community from GIS. I am not sure that wheather i will be able to run the model after adding community shapefile. Curretly i have not added Pumps, Reserviour etc ...Although i have added community shapefile....Can you guide me regarding this issue.????

0 Offline MPachlhofer Wed, Aug 24 2016 12:07 PM
Adnan,

It's not going to do much good to run a model without all the elements of your system input because the data you're going to get back is not going to mean anything. Given that information, if you'd like to run your model it will need the demands input and a source of water. Those are the minimum requirements in order to run a model.

Regards,
Mark

Mark
Cancel
Vote Up 0 Vote Down

Cancel