Note: AutoPIPE 10.01.xx and higher, see the following AutoPIPE help section:
Help > Contents> Contents Tab> Bentley AutoPIPE> Supplemental Documentation> on this page scroll down to see a hyperlink for "Hydrotest Tutorial"
Comments, Questions, and Answers
Item #1: V-stops are not allowing lateral movement during
Item #2: Non-linear analysis method
Item #3: Report: Hydrotest load case settings
Item #4: High results values
Item #5: AutoPIPE V8i 09.06.01.10 and higher new hydro test method
Item #6: Allowable K Factor = 0.9
Item #7: Allowable: user defined
Item #8: Allowable value calculation
Item #9 Please select a valid test pressure case for B31.3 test pressure update
Item #10: Difference results between the Normal Sustain load (ex. Gr+MaxP (1)) and the Hydrotest Sustain load (ex. Gr+MaxP (2))
Item #11: Apply more than one hydro-test analysis sets
Item #12: Hydrotest load are not applied on a segment
Item #13: W88-24: Allowable based on cold yield Sy may be un-conservative
Item #14: Gravity load case results weigh more than the Hydrotest gravity load case results
Item #15: Change test pressure and temperature
Loads and Load Sets - AutoPIPE
Bentley AutoPIPE