iModel NOT showing on IPad

Question

Hi, 
 I have installed Microstation CONNECT and saved a 3D-Model as a imodel (also published to Personal Share) 
 Afterwords I installed Navigator on my Ipad and I used the same login as I use for microstation CONNECT. 
 My imodel is not listed in Navigator? What do I wrong? When I try to start a new Project, a window popup like showing above... 
 
 Best regards 
 
 Arjan Molenaar

Darius Rimasauskas · Accepted Answer

Additionally you may look at Navigator CONNECT Edition getting started support solutions: http://communities.bentley.com/products/projectwise/project_review/w/wiki/23510.3-opening-an-i-model 
 In Navigator CONNECT Edition you can open *imodel from "Personal Share", "Project Share", "Local drive". You have published *.imodel from MicroStation to "Personal Share" so in Navigator "Open" view select "Browse" button and then select "Personal Share":

Regards, Darius

Tamicca Sellars · Answer

Hello Arjan, 
 
Publishing an i-model to your Personal Share is not the same as creating a project communities.bentley.com/.../23737.personal-share . In order to create project you need to be a site administrator, co-administrator, or project administrator (see communities.bentley.com/.../25124.user-management for definitions of each role). 
 
Here's information on the Project Portal that may help communities.bentley.com/.../23735.project-portal