Cross Section Viewing in SS4

All: Vern and I have been looking at the problem of viewing the corridor cross sections. I can see the plan, profile, and 3d model perfectly fine, but when I try and view the cross sections, the screen comes up blank. I I hover over an object in the 3D view, it highlights in the cross sectional view like it is there, but you still cant see the elemants in the view. Anyone else haveing this issue?

Thanks

 

Gary E Gaiotti | Technical Specialist IV | Michael Baker International
1320 Executive Ctr. Dr. | Tallahassee, FL 32301 | [O] 850-701-2316 | [M] 850-556-7100
gegaiotti@mbakerintl.com | www.mbakerintl.com

Parents Reply Children
  • I have been having this issue. the "delete dynamic cross section view" did not improve the situation. I am not seeing either existing or proposed surfaces. It must have something to do with 3d/2d models, and active surfaces, but I am new to the design. Here is what I have:

    view 1 shows the 2d model along with existing contours. my only reference is the terrain as a 2d model
    View 2 shows both existing and proposed profile. I have no references
    View 3 shows a blank dynamic cross section view, centered on zero. Reference is a 3d model of the file I am in.
    View 4 shows the 3d proposed model (excludes existing). reference 2d terrain model

    view 1 and 4 clearly show that the model ran. I'm not sure why neither the existing nor proposed cross sections are being shown in the dynamic cross section view.

    I have checked all my references and none have the "ignore attachment when live nesting" button active.

    Power Geopak V8i SS4 08.11.09.878

    Any assistance you can provide would be greatly appreciated.