Has anyone found it difficult to store a profile in SS4 which has back to back vertical curves that fall on the same point? For some reason I can't create a profile using the end of a vertical curve as the beginning of the next vertical curve. I know there will be a training tomorrow on using the tools. However, I found myself creating the profile in SS2 since its much easier. But now I can't import the created profile onto the SS4 alignment. If anyone has any tips it would be greatly appreciated!
Your geometry is "too complex" for this version of OpenRoads. You cannot have "adjacent parabolas". See the reply I received on a similar problem. http://communities.bentley.com/products/road___site_design/f/5922/p/95069/277335#277335