Project Stationing

Is there a way to project from one civil element to another.  For example.  My PGL will be based on the CL stationing.  Is there a way to project the CL stationing on to the PGL stationing? 

Parents
  • Navon,
    This is accomplish typically be projecting the PGL Profile on to the Centerline Profile. A profile is ruled to a specific Horizontal Alignment in OpenRoads. In order to view the PGL profile with the Centerline stationing it can be projected using the Vertical Alignment tools. This projected profile will be a "stroked" profile, meaning it will not contain the same geometry as the original profile on the PGL alignment. It is reduced to (PVI)s at a constant interval. If your PGL is to use CL stationing and typical profile geometry; i.e. PI's, Parabolic Curves, etc. , It should be created on the CL. Then it can be used as a Point Control on the corridor to override the template PGL point vertical constraints.
    Vern
    FDOT CADD Office Support

    Vern

Reply
  • Navon,
    This is accomplish typically be projecting the PGL Profile on to the Centerline Profile. A profile is ruled to a specific Horizontal Alignment in OpenRoads. In order to view the PGL profile with the Centerline stationing it can be projected using the Vertical Alignment tools. This projected profile will be a "stroked" profile, meaning it will not contain the same geometry as the original profile on the PGL alignment. It is reduced to (PVI)s at a constant interval. If your PGL is to use CL stationing and typical profile geometry; i.e. PI's, Parabolic Curves, etc. , It should be created on the CL. Then it can be used as a Point Control on the corridor to override the template PGL point vertical constraints.
    Vern
    FDOT CADD Office Support

    Vern

Children
No Data