Cross Section End Conditions Not Working

I have created a very simple model (just starting with SS4) and after viewing the cross sections the end conditions (cut & fill) are not working correctly. For some sections, they work fine, for others they cut across the ditch and tie in to the other side (picture below).

Any help would be appreciated.

Top Replies

Offline Zachary Billings Tue, Jun 20 2017 1:34 PM in reply to Brian Gacke +1

Can you make sure your end conditions are infinite. It almost looks like that end condition is set to a fixed length, so if the tie point is further than that length, it won't be able to draw it. Or…

Offline Zachary Billings Mon, Jun 5 2017 1:28 PM
Check your affixes. You probably did not apply affixes to your tie down point names, so they are trying to connect to eachother. Make sure you have LT and RT in your point names and in the override name so they know which side to connect on.

Zachary Billings, P.E.

Senior Roadway Engineer (Licensed in FL and MI)

CONSOR Engineers, LLC

System Info:

Windows 11 | Intel Core i7-13700k | Nvidia RTX 4090 FE | 32 GB of RAM | 2 TB Western Digital Black SN850x NVME

ORD Version 10.12.02.004 | FDOT Connect Version 10.12.01.00

YouTube Page for ORD: https://tinyurl.com/BillingsCADD
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Offline Brian Gacke Mon, Jun 5 2017 2:09 PM in reply to Zachary Billings

That worked, but now some of the links don't show up even though the tie in point exists on the section (see picture below).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Offline Brian Gacke Tue, Jun 20 2017 1:04 PM in reply to Brian Gacke

This is happening on a different project now. Any help would be appreciated.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Offline Zachary Billings Tue, Jun 20 2017 1:34 PM in reply to Brian Gacke
Can you make sure your end conditions are infinite. It almost looks like that end condition is set to a fixed length, so if the tie point is further than that length, it won't be able to draw it.

Or, if you are using the FDOT end conditions with the 1:6, 1:4, 1:3, 1:2, only the 1:2 should be infinite. All of the other ones are set up to only fill to their specified depths.

If you post your .itl, I can take a look

Zachary Billings, P.E.

Senior Roadway Engineer (Licensed in FL and MI)

CONSOR Engineers, LLC

System Info:

Windows 11 | Intel Core i7-13700k | Nvidia RTX 4090 FE | 32 GB of RAM | 2 TB Western Digital Black SN850x NVME

ORD Version 10.12.02.004 | FDOT Connect Version 10.12.01.00

YouTube Page for ORD: https://tinyurl.com/BillingsCADD
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel
Offline Brian Gacke Tue, Jun 20 2017 2:26 PM in reply to Zachary Billings

That worked, thanks!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel