Cross Section End Conditions Not Working

I have created a very simple model (just starting with SS4) and after viewing the cross sections the end conditions (cut & fill) are not working correctly. For some sections, they work fine, for others they cut across the ditch and tie in to the other side (picture below).

Any help would be appreciated. 

Parents
  • Check your affixes. You probably did not apply affixes to your tie down point names, so they are trying to connect to eachother. Make sure you have LT and RT in your point names and in the override name so they know which side to connect on.
Reply
  • Check your affixes. You probably did not apply affixes to your tie down point names, so they are trying to connect to eachother. Make sure you have LT and RT in your point names and in the override name so they know which side to connect on.
Children