Stub Out Report Prompt Not showing

Screen captures would be useful. One thing I know is that it doesn't like spaces in pipe names etc.

Screen captures would be useful. One thing I know is that it doesn't like spaces in pipe names etc.

was able to get the stub out report prompt on this run, but immediately locks up after the first section. 

Are you able to share the .txt file that is generated for the run? Sometimes it will have clues as to where the problem is occurring. Also, try a run with unchecking "Pause On Each Section."

If I try to run with unchecking "Pause on each section." The entire process would just freeze.  And here is the text file.  Thanks.xs_temp.log

Not sure if this is significant as to why the freezing occurs. However the log is stating that no matching XS Cells are found for the given XS Pattern Lines. Be sure that pattern lines exist for the structures and there are cross sections that match the same structure locations. Hope this helps getting to the problem.... I'm not a fan of this system, since there are too many steps/variables to be able to produce an accurate cross section that has drainage structures shown properly.

I just went through something like this. What ended up being the problem for me was something wrong with my first pattern line. Perhaps the drainage structure there had something wrong with it in the gdf? Anyway, after I had already created all of my cross section cells with existing ground from my pattern lines, I then deleted that first pattern line before I attempted to run the Drainage Structures in. Once I did that, the stub report prompt came up and everything ran in just fine. I have yet to figure out why that first section doesnt work, but we are just going to draw it by hand for the time being.