Stub Out Report Prompt Not showing

Attempting to run proposed sections, after selecting Run and Apply, the prompt for the stub out report does not appear and everything locks up.  I tried on two other pcs and the prompt for the stub out report still doesn't show. Does anyone have an idea what could be wrong with it? Thanks.

Parents Reply Children
  • If I try to run with unchecking "Pause on each section." The entire process would just freeze.  And here is the text file.  Thanks.xs_temp.log

  • Not sure if this is significant as to why the freezing occurs. However the log is stating that no matching XS Cells are found for the given XS Pattern Lines. Be sure that pattern lines exist for the structures and there are cross sections that match the same structure locations. Hope this helps getting to the problem.... I'm not a fan of this system, since there are too many steps/variables to be able to produce an accurate cross section that has drainage structures shown properly.

  • I just went through something like this. What ended up being the problem for me was something wrong with my first pattern line. Perhaps the drainage structure there had something wrong with it in the gdf? Anyway, after I had already created all of my cross section cells with existing ground from my pattern lines, I then deleted that first pattern line before I attempted to run the Drainage Structures in. Once I did that, the stub report prompt came up and everything ran in just fine. I have yet to figure out why that first section doesnt work, but we are just going to draw it by hand for the time being.

    Zachary Billings, P.E.

    Senior Roadway Engineer (Licensed in FL and MI)

    CONSOR Engineers, LLC

    System Info:

    Windows 11 | Intel Core i7-13700k | Nvidia RTX 4090 FE | 32 GB of RAM | 2 TB Western Digital Black SN850x NVME

    ORD Version 10.12.02.004 | FDOT Connect Version 10.12.01.00

    YouTube Page for ORD: https://tinyurl.com/BillingsCADD