About Bentley Communities

Communities Feedback Forum I need all properties UC ratio in this small shed project

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

I need all properties UC ratio in this small shed project

Offline arul mani over 4 years ago

Offline arul mani Wed, Jun 12 2019 7:55 AM

If ther is properties not available means please assign cold formed steel and check the uc ratio.....
Cancel
Vote Up 0 Vote Down

Cancel
Offline Jesse Dringoli Wed, Jun 12 2019 9:19 AM
Hello, which Bentley product are you using, and what version? You have posted in the Communities Feedback forum, which is for discussions about using Bentley Communities. I can assist in moving your post to the appropriate Product Community forum.

Regards,

Jesse Dringoli
Technical Support Manager, OpenFlows
Bentley Communities Site Administrator
Bentley Systems, Inc.
Cancel
Vote Up 0 Vote Down

Cancel
Offline arul mani Wed, Jun 12 2019 9:44 AM in reply to Jesse Dringoli

V8i (SELECTseries6)
Cancel
Vote Up 0 Vote Down

Cancel
Offline Jesse Dringoli Wed, Jun 12 2019 10:09 AM in reply to arul mani
That is a version number, but what product are you using? (MicroStation, RAM, STAAD, SACS, etc). Please refrain from posting multiple times with the same question (I deleted your duplicate posts).

Regards,

Jesse Dringoli
Technical Support Manager, OpenFlows
Bentley Communities Site Administrator
Bentley Systems, Inc.
Cancel
Vote Up 0 Vote Down

Cancel