This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Staad pro analysis

Can anyone please help me to understand the following issue which I am confused about displacement check. I am a novice in staad pro. 

My question is, should I check the displacement of a full-length beam or the segment of a beam that is cut in many segments due to make plate mesh above the beam.

If my question is not clear please let me know.

  • Abu, you have posted in the Communities Feedback forum, which is intended to discuss feedback about the site itself. Product Support is handled in the individual product community forums. I see you have posted the question on the RAM | STAAD forum here. Please use that thread to discuss this issue, as the STAAD Support team monitors that forum.


    Regards,

    Jesse Dringoli
    Technical Support Manager, OpenFlows
    Bentley Communities Site Administrator
    Bentley Systems, Inc.