Mike.McGinnis

RE: SpecGen: Create New Catalog. Placing FLEX HOSE in OPM. Not sure which (or both) is the issue.

Deepak Singh

Hello Mike, Thanks a lot for raising SR on your concern, OpenPlant Modeler requires important parameters & correct table definition to be placed in OPM. Please refer below attached video that explains the workflow to create Flexible Hose in OpenPlant…
- over 4 years ago
- OpenPlant | AutoPLANT
- OpenPlant | AutoPLANT Forum
RE: OPIM Output Dims don't match active DimStyle from Isoseed.

Abhijit Bute

Hello Mike, Thanks for your question. Could you please change following variable in Style.cfg. IE_FMT_DIMENSION_FEET_INCH_SEPARATOR = @-@ Also please refer following communities which will guide you detail steps: How to…
- over 4 years ago
- OpenPlant | AutoPLANT
- OpenPlant | AutoPLANT Forum
RE: OPM Pipe Level name generated from Pipeline Tag

Tuan Le

I think this wiki article could be what you're looking for: How to Edit Pipeline Level Naming Rule in Named Expressions Applies To Product(s): OpenPlant Modeler V8i Version(s): 08.11.09.XXX (SS5) |…
- over 4 years ago
- OpenPlant | AutoPLANT
- OpenPlant | AutoPLANT Forum
COMMUNITIES

Mike.McGinnis

I need assistance with my Bentley Communities profile. Is there a Bentley COMMUNITIES community?
- Answered
- over 4 years ago
- About Bentley Communities
- Communities Feedback Forum
OPIM Dimension Config

Mike.McGinnis

So, I'm new to the OPIM world, so sorry if this question is off-the-charts basic in nature. What controls the way the dimensions look? I've worked thru the report.def, and got my BOM looking the way I want. I can't seem to figure out a way to effect…
- over 6 years ago
- OpenUtilities
- OpenUtilities Substation | Promis.e Forum

Mike.McGinnis

RE: SpecGen: Create New Catalog. Placing FLEX HOSE in OPM. Not sure which (or both) is the issue.

RE: OPIM Output Dims don't match active DimStyle from Isoseed.

RE: OPM Pipe Level name generated from Pipeline Tag

COMMUNITIES

OPIM Dimension Config