Ok, I found the answer.........The Pivot Edge is going in the wrong direction, switch the pivot edge to the correct side.
For accessing Bentley OpenRoads Designer training videos, please visit the Tennessee DOT website:
https://www.tn.gov/tdot/roadway-design/tdot-cadd-support/tdot-openroads-designer/ord-tutorial-videos.html
They figured something out that makes it much easier…
There are some very easy fixes to the problems that you are experiencing.
Below are the End Condition Exceptions that are causing the problems:
The first problem I see is that the right override is not solving at STA 603+25:
If you go into the End…
Since InRoads allows multiple vertical alignments on a horizontal alignments, I have found that using a ditch vertical alignment with a separate horizontal alignment for the ditch centerline makes it easy to controll the ditch elevations since the station…
Typically if you are entering in a specific stationing in the Roadway Designer, it adds that station value into the Key Stations. In the Roadway Designer, go to Corridor > Key Stations and you can select and delete any or all Key Stations that are listed…
