Bentley Communities
Site
Search
User
Site
Search
User
Welcome
Products
Support
About
More
Cancel
Lemuel Ramos
Likes
Profile
Activity
Communities
Friends
Likes
Achievements
Bookmarks
Blog Posts
Questions
More
Cancel
RE: How to display total weight of structure in staad pro? my model is concrete slab and beam, and steel pipe piles.
DSANJU
You can add PRINT CG command after PERFORM ANALYSIS. This would report weight of the structure.
over 7 years ago
RAM | STAAD | ADINA
RAM | STAAD Forum
RE: **Warning - this structure is disjointed, *warning: if this ubc/ibc analysis has tension/compression, etc.
Sye
As far as the warning related to the UBC/IBC is concerned, you may refer to the discussions in the post below https://communities.bentley.com/products/ram-staad/f/ram-staad-forum/91953/ibc-ubc-warning-in-my-canadian-seismic-load-model/264284#264284
over 3 years ago
RAM | STAAD | ADINA
RAM | STAAD Forum
RE: **Warning - this structure is disjointed, *warning: if this ubc/ibc analysis has tension/compression, etc.
AndrejLogunov
Beam 40 and nodes 76 and 87 are not attached to whole structure. Beams 2219 and 2220 are duplicate. There are also overlapping collinear members and poor beam-plate connectivity - go to Utilities and check with the tools on top left side of the ribbon…
over 3 years ago
RAM | STAAD | ADINA
RAM | STAAD Forum