Robert Alleway's Activities

LIDAR LAZ FILE UPLOAD -TRAJECTORY FILE -TIME DATE STAMP MISSING-ERROR MESSAGE

C3D Designs — Thu, 17 Oct 2019 23:49:58 GMT

GOOD DAY ALL

Please, can you help..

received this trajectory file data with our lidar dataset, but when we filter the time stamp (as being column1-208706.00806 etc as per the information received it gives us this error)

what am I going wrong or is the error in the trajectory information received

Context Capture: "Could not prepare Task..."

Fernando Garcia — Fri, 21 May 2021 07:08:52 GMT

I am using the 7-day trial version of context capture. I have completed an Aerotriangulation and New Reconstruction. The problem is when I go to "Submit new Production", the ContextCapture Engine says that it could not prepare task and could not run task. Then the Production jobs remain as pending forever and never start. There is nothing else in the job queue. Is this a problem with the trial version or could there be some other problem?

CCEngine Error message

Robert Alleway — Wed, 12 May 2021 00:33:34 GMT

Hi Team,

I have noticed recently that my CCEngine now displays error messages as below when running an AT. I'm not certain what is causing this error or whether it is impacting the processing time.

Has anyone else found this since updating to V17? And are there any changes I should be making to PC or software to avoid?

Excerpt from CC Engine below

[2021-May-12 09:52:33] Could not check Engine signals, retry in a few seconds. Running task is not impacted.
[2021-May-12 09:52:34] Engine signals recovered!
[2021-May-12 09:56:38] Could not check Engine signals, retry in a few seconds. Running task is not impacted.
[2021-May-12 09:56:40] Engine signals recovered!

Updating/Patching previous ContextCapture 3D Model

Horacio Gutierrez — Thu, 09 Jan 2020 12:30:17 GMT

Hello everyone,

I was wondering if is there any known way of "updating" a 3D model (.3mx) created in ContextCapture, just for the sake of not processing the whole project again.

In other words, what I need is to process a small portion of a previously flown area, for which I already created a .3mx a while ago. The purpose of this would be to modify/update that small area over the 3d mesh that I already have. In doing so, I assume it would take me less time to process and would get me a model that is up to this date, without having to reprocess the unchanged areas.

Hope it's clear. Any help is appreciated.

Thank you.