Boyan Borisov

Hello Boyan, You can create these from the Transient Results Viewer. There is a Time History tab. You will need to include report points for elements in your model. This is done in the transient calculation options. You have options to include all elements…

Boyan Borisov said: Which volume is given in the second column on Figure 2 and 3, after calculation based on initial conditions? It is the volume of gas in the tank - when the tank is connected to the system and subjected to system pressure, the gas…

Hi Boyan, Your tank is set to use a bladder (has bladder = true) in which case HAMMER assumes that the pressure inside the full bladder is equal to the "preset pressure" (98 Kpa in your case) before the tank is installed and subjecting the tank to pipeline…

Hello Boyan, Assuming you are using HAMMER, this information is stored in the Transient alternative. You can create two of Transient alternative with two different air valve settings for two scenarios. You can find more information on managing scenarios…

Hi Boyan, Can you clarify what you mean by "emitter node"? Do you mean a junction with an emitter coefficient? If so, HAMMER treats this situation the same as a regular demand node during the transient simulation - it sees the initial pressure and outflow…