Boopathiraj Krishnan's Activities

Power rail track get crashed while opening the time

Boopathiraj Krishnan — Thu, 14 Oct 2021 05:20:09 GMT

Dear All,

I have facing issue on while opening the PRT automatically get closed I'm not able to work . Even I try with ignore option and retry option also PRT get closed, the screenshot pasted below please help me how resolve the issue.

Calculate Earth work Quantity based on cross section

Boopathiraj Krishnan — Wed, 15 May 2019 05:15:48 GMT

Hi friends,

I have some query about the earth work calculation when we generated cross section based on existing surface and design surface then normally the volume quantity comes fill & Cut some amount in the section and normal get the prepared sub-grade volume for full section, My case i have existing embankment but this for MG standards now i'm widening the embankment of BG standards of both side on existing embankment location below i attached image.

below that image shown green hatched for existing ground and white color hatched portion of widening embankment in there when i check quantity of the quantity in end area volume i got the 100% of new prepared sub-grade but i want the quantity like prepared sub grade fill = 40 m^3 new and prepared sub grade cut = 60 m^3 of existing portion,but i could't find it if there is any other option are available to resolve my query please let me know ASAP.

Regards,

Boopathiraj

End conditions of fill

Boopathiraj Krishnan — Thu, 01 Nov 2018 09:58:36 GMT

Dear All,

Bentley user i have some doubt for when i test for 3% slope that time the blanket of fill was not going properly along the fill. Please help me out how to correct the condtion ASAP.

When i'm going to cut i want the image 2 type but i'm getting like image 1 type how to resolve it. I attached the ITL file also.

Regards,

Boopathiraj

communities.bentley.com/.../BR-Model.itl

To set the components rule in template

Boopathiraj Krishnan — Wed, 05 Sep 2018 10:27:54 GMT

Dear friends,

I have issue in my template the end condition ( fill and cut) not working properly when i go for cut the drainage profile should shown at of bottom the blanket but my template it not shown (picture 1) when i reach the level for 0,0 then only the drain profile is visible for (picture 2).

Picture:3 There was problem for when i'm going to the fill end condition of embankment the fill line was not visible while test the template.

How to resolve the issue please help me anyone ASAP.

picture:1

Picture:

Picture:3

Regards,

Boopathiraj

Creating Cross Sections

Arif Ali — Sun, 24 Dec 2017 14:14:42 GMT

Hi,

Can anybody help me in creating BRT templates for elevated track. Is there any workflow which can be followed?

I look forward your feedback.

Thanks,

Arif.

How setup google earth image view in SS4

Boopathiraj Krishnan — Wed, 28 Mar 2018 02:14:16 GMT

Hi,

I have one doubt about the civil 3D there one option of using bing map like aerial map command that map assigning coordinates system it similarly in PRT method but in PRT only allows for only capture image type but i need that whatever coordinate assign that all bing map we can use in PRT. Please help me anyone if know's how to setup the bing maps in PRT SS4.

Regards,

BOOPATHIRAJ

Ask A Question I

Wed, 28 Mar 2018 02:14:17 GMT

Ask a question in a forum.