OpenPlant Modeler does report, but limited output only. However Scope of OpenPlant Orthographics Manager is growing, as it will furnish all the possible details which is required as an output. I would recommend you to Install OpenPlant Orthographics…
Try below link, which will guide you to offer some courses:
I recommend the second method for building Loops. I would place the instruments needed and add the instrument lines. Then select all instruments and click on Instrument Loop.
I hope this helps,
In case you have a situation where the instruments are already placed - you can select all of the instruments in the PID and then initiate the Instrument Loop tool. You will be prompted if you wish to add the selected components to a Loop. Select Yes…
Hello Amber Vick,
The Bentley Communities is a great place to get the information you need. Make sure to check out the Wiki Post located in the Plant Design and Engineering Community.