amicron's Activities

Add an additional engine using OneDrive

amicron — Mon, 19 Dec 2022 17:42:27 GMT

I was wondering if I put the job queue on OneDrive, can I add an additional engine on another computer that sees that same OneDrive folder?

Thanks!

Camera Calibration

amicron — Thu, 29 Apr 2021 15:58:52 GMT

I am processing photos from a Phase One camera with an accurate camera calibration but Im not sure exactly what is happening when I enter the calibration for processing. Is it using the calibration during processing or are the values I enter only used as a comparison to what Context Capture gets?

Also, the camera came with 3 different calibrations - Australis, USGS, and INPHO. I think I use Australis but Im not positive because if I let Context Capture adjust the calibration, the distortion values are not even close to what I entered.

Any help with understanding the camera calibration aspect of Context Capture would be great.

Thanks!

Geometry Constraints in Cloud Processing Console

amicron — Wed, 08 Sep 2021 13:18:42 GMT

Why are the geometry constraint buttons greyed out in the cloud processing console? Can't figure out how to make them active.

I need help processing thermal images

amicron — Tue, 20 Oct 2020 18:21:08 GMT

I have photos from an XT2 that I can't get to process. There must be some trick to it that I can't figure out. We flew the site at 90% overlap and it looks like there is plenty of overlap but they will not process. Do I need accurate camera/lens properties? Where can I find those? Is there a specific fisheye correction I need to use? RGB pictures process just fine. ANY help is appreciated. Not sure what else to do.

Thank you!

Any benefit to processing in phases (adding pictures)?

amicron — Tue, 29 Sep 2020 15:48:02 GMT

Is there any benefit to processing one set of pictures then adding more pictures and processing again? does it keep the original main component and add to it or does it start over completely?

I am asking because I am trying to get pictures from an XT2 to process. The thermal images will not process on their own because the smaller footprint was not accounted for so I am trying to process the RGB pictures first then add the thermal. Is that a waste of time? Is there a better way?

thank you!

merge orthos into one image

amicron — Thu, 22 Aug 2019 13:38:13 GMT

How do you make one ortho image from all the separate tiffs CC creates?

Thanks!

Ask A Question I

Thu, 22 Aug 2019 01:24:39 GMT

Ask a question in a forum.

DJI Phantom 4 RTK Ntrip Processing

Keith Lam — Sun, 10 Mar 2019 15:24:28 GMT

Hi,

I am processing the DJI Phantom 4 RTK data, which are corrected through Ntrip. Without putting any GCP into model construction, the horizontal accuracy is doing well like 5cm. However, the vertical accuracy is terribly wrong as 2m. It seems there is a problem of wrong vertical coordinate system. The vertical values of the model were imported as orthometric height with reference to Hong Kong Principal Datum. Is there any method like Pix4D that I could change the vertical coordinate setting as arbitrary but not egm96?

Thanks!