Results Along Line

Patrick Stelmach — Tue, 19 Jul 2022 13:57:29 GMT

Is there any way (such as programing cut lines into the input file/saving your cut lines) to not lose cut lines after making modifications to the model and re running the analysis?

I found a post about this two years ago and I'm not sure if any enhancements have been made since then.

Results Along Line - RAM | STAAD Forum - RAM | STAAD | ADINA - Bentley Communities

Thank you!

Design Parameters Not Appearing in Postprocessing

Patrick Stelmach — Fri, 27 May 2022 15:07:09 GMT

Hello,

I have defined multiple parameters in order to check different load combinations for different groups as shown in the portion of the input file I pasted below.

LOAD LIST 1101 TO 1104 1201 TO 1204 1301 TO 1320 1401 TO 1412 1501 TO 1504 -
1601 TO 1612 1701 TO 1704
PARAMETER 1
CODE AISC UNIFIED 2016
METHOD LRFD
CHECK CODE MEMB _SELFWEIGHT

*
LOAD LIST 1101 TO 1104 1201 TO 1204 1301 TO 1320 1401 TO 1412 1501 TO 1504 -
1601 TO 1612 1701 TO 1704 3000 TO 3007
PARAMETER 1.1
CODE AISC UNIFIED 2016
METHOD LRFD
CHECK CODE MEMB _COLLECTOR

I am using AISC 360-16 and per this article (https://communities.bentley.com/products/ram-staad/w/structural_analysis_and_design__wiki/58878/viewing-results-for-multiple-design-parameter-blocks) I should have a design parameter drop down pop up. However I don't have this pop up in the postprocessing results menu with or without the additional parameter definition. I have attached a screenshot of what my postprocessing results menu looks like.

How do I get this design parameter section to show up?

Thank you!

Ask A Question I

Fri, 27 May 2022 01:24:49 GMT

Ask a question in a forum.

Patrick Stelmach's Communities Activities

Results Along Line

Design Parameters Not Appearing in Postprocessing

Ask A Question I