ce_pankaj's Activities

Rail Track Design Software

ce_pankaj — Thu, 02 Jan 2020 04:56:32 GMT

Hi Team,

I am BRT/PRT user since 2008. Now, I am working as a freelancer for different railway clients on contractual basis. I need a Power Rail Track software subscription as single user. My requirement is little, may I know what is the best way to get the licence software with minimum budget.

Thank you in advance.

Regards

Pankaj

Creating New Turnout

ce_pankaj — Sun, 12 Nov 2017 16:34:08 GMT

Hi All,

While creating the turnout one message is pop up negative or zero arc length. I have verify all the data by drawing as well as hang calculations it is ok. What to do next kindly suggest.

Thanks in advance.

Regards

Pankaj

Ask A Question I

Sun, 12 Nov 2017 09:20:27 GMT

Ask a question in a forum.

Profile Annotation

ce_pankaj — Wed, 12 Feb 2014 08:47:05 GMT

Hi All,

I just want to know something about Power rail track:-

1. Is it possible to annotate two or more vertical alignment in the profile & How?

2. Like roadway designer Can we annotate the offset distance between two alignments in the profile & How?

Thank you

Pankaj

Curve widening for Two or more tracks

ce_pankaj — Wed, 05 Aug 2015 10:51:23 GMT

Dear All,

I have seen some blogs related to curve widening however, most of the solutions are considering the single track only. My problem is that i have either two or more tracks. I just want to confirm weather it is possible to assign the curve widening for two or more tracks simultaneously if my control point is the main line. Then, how to assign the curve widening for other loop lines. If yes/no then what is correct procedure to assign the curve widening for two or more tracks.

It would be grateful to me for prompt reply.

Thanks & Regards

Pankaj

Cross sections

ce_pankaj — Fri, 22 Mar 2013 15:58:44 GMT

Hi Everyone,

I have been using roadway designer through power rail track for creation of cross sections. I have designed the corridor with the template its working as defined in the conditions. Unfortunately i am not able to place the set template in the cross sections. I would be grateful if someone can help me.

Thanks & Regards

Pankaj