Joseph Mekaeil's Activities

Corridor Modeler Proposed Cross Sections From DTM

jthdr — Wed, 06 May 2015 19:39:51 GMT

I can't seem to get proposed cross section elements to draw on my existing ground cross sections. I run the process and it works through the cross sections but draws nothing. Any solutions? A colleague in another office was able to do it, so I am assuming I have a setup problem.

Cannot figure out how to make cross sections SS3

Joseph Mekaeil — Thu, 15 Mar 2018 15:33:33 GMT

I'm trying to cut cross sections of my horizontal alignment which is preloaded in an .alg file. Here's the process i follow:

1.) I "View Active Horizontal" in order to display my horizontal alignment.

2.) I click "Create Cross Sections" under the Corridor Modeling task.

3.) It then prompts me to select the alignment graphic...i click on the line generated in the first step.

4.) I set my intervals and all the settings

5.) It opens up a new model but this model is blank. No cross sections were generated. I tried to Fit to View but there is simply no info.

Note: After selecting the alignment in step 3, the dialog does not read out the alignments name which leads me to think that it didn't really select it. Photo attached below.

Ask A Question I

Thu, 15 Mar 2018 03:05:27 GMT

Ask a question in a forum.