Remove Batch from Isogen Title Block

Batch Ref is a is a default reference included in the isogen title block which references the Area value as displayed in the image below:

With Batch

Batch can be removed by editing a file in the Isogen style in use (example FINAL) and editing the position file final.pos.  Because the batch reference a default value it is not required in the .pos file for placement.  To change the default location or to remove the batch reference -10 must be entered in the .pos file.

To remove the batch reference -10 must be entered into .pos file and then the X and Y coordinates must be set to X=0 and Y=0 (setting the coordinates to 0,0 will not allow the entry to be place in isogen).  For example open final.pos and add the following line:

                            Table Table Numb  Numb
Text    X   Y Char   Char  Offset Offset of   of    Table
ID No Pos Pos Width Height in X    in Y  Cols Lines Dir
----- --- --- ----- ------ ------ ------ ---- ----- -----
-10      0    0 200 250     0     0     0     0     0
-615 40550 1950 200 250     0     0     0     0     0
-616 40550 1550 200 250     0     0     0     0     0

 

Once the above entered in the pos file the aforementioned section of the title block with Batch Ref will change to the following:

Without Batch