LumenRT weather issue

Hi Elroy,

This is something new, which version of LumenRT you are using what was your work flow?

Regards
Ankur

Hi Ankur, asmentioned above it's 2016. I was experiencing some random unpredictable issues when exporting directly from powercivil into LumenRT. Whenever I exported a project it would place it close to the edge of the LumenRT scene or sometimes just outside the LumenRT scene and because of that I would not be able to navigate over certain parts of the model. So the workflow I followed involved creating an OBJ file of the project and importing the OBJ file into LumenRT. Once inside LumenRT I was able to move the project to a location that I was happy with and then start working on it.

Hi Ankur, asmentioned above it's 2016. I was experiencing some random unpredictable issues when exporting directly from powercivil into LumenRT. Whenever I exported a project it would place it close to the edge of the LumenRT scene or sometimes just outside the LumenRT scene and because of that I would not be able to navigate over certain parts of the model. So the workflow I followed involved creating an OBJ file of the project and importing the OBJ file into LumenRT. Once inside LumenRT I was able to move the project to a location that I was happy with and then start working on it.

Hello Elroy,

when you exported the model into LumenRT you should check few things.

1. the camera setting must be 50% so that the movement of your fly through mode is smooth. As you can see in the Snape short

2. the model once exported into LumenRT can be move to any location in the scene, you just have to unlocked this, you can see the Snape short below.

this to things might help you.

Regards,

Ankur  

Hi Ankur. The Snapshots don't seem to be showing up on my side. Can you try to attach them again? Thanks