Hello,My X, Y, Z data from photos are wrong - they are moved around 30 m further than they were taken. The model was computed in the right way but still it was draged by some distance.
I can change the coordinates of each photo but it would take some time. Is there any possibility to manually write the correct X, Y, Z to the created model in the ContextCapture programme?Olaf
Hi Olaf,
If you have coordinates for items that are visible in the photos you can enter the known coordinates as "control points" in the Surveys tab. When you enter a control point you also manually mark that point on several photos, so the software can use this information to adjust the results to match these control points during aerotriangulation.
Regards,Ron