Hello, with the last update 10 of CCE, I try to do the same as in the video exemple, https://www.youtube.com/watch?v=BN0q-5YbMbY&t=62s
I use the same datasets, but it seams there are some differents :
So how to achieve to have the same result ? I tried to clear pose metadata but I never have the same for the begining for the picture, so it is not possible to use point cloud for adjustment.
Can you explain how to do ?
thank,
Fabrice
Just looking at sample data .. versus yours:
1) need to import the optical properties and apply to the photogroup. There is an *.opt file in there - so right click on photogroup and import.
2) import positions - "," as delimiter, ignore first line, non-georeferenced, leave others unticked
3) run an AT .. keep camera calibration .. I usually set tie points to High
4) in the new AT'd block - import point cloud as static scans - I changed SRS to non-geo
5) check your 3D view to visually inspect alignment .. looked ok to me ..
5) re-run AT - try rigid or adjust for point cloud - your call - keep camera calibration again
6) recon .. stay tuned.
Answer Verified By: Fabrice K
Hi James,
thank you very much for these complete explanations. now everything OK. I think I have differences between the first data and these one. but everything is ok. I will give a try to my own data.
Cheers,
How did you go with the reconstrution? Mind didn't come out quite like the video - had some artefacts on the roof.
Hi, I have the same problem.
With tradition import, but with all georeferenced, i didn't had that problem.
I tried adjust and rigid .. no joy. Anyone else? Is the hybrid recon broken? I've been having trouble with all hybrid recons - have given up and am meshing the laser only .. baking on the textures.
Adjust:
Rigid:
Hello James, this should not happened, at least not at that extent. Can you go to the Project Files/Block/Model and open geometry.a3d with Context Capture Viewer, press T and take a screenshot of the model. This will help me to know what's going on. Thanks
Few shots as requested ..
Different project .. but basically I haven't been able to run a hybrid photo + laser recon ..
AT looks fine .. as it has with all of them .. bit hard to tell with a screenshot - but no stray tie points anywhere.
This is the recon with LASER ONLY.
Photos + Laser for geometry.
Recon was unusable .. happened with version 9 - heard this was a bug being fixed with 10 - re-ran the AT in 10 .. no better.
Hi James, this is definitively troubling since I cannot reproduce the issue on my side. Would you mind filling a Support Request for your bridge problem and asking that I look into it? I'll need to data to try to reproduce the issue on my end. Thanks
Hi Cyril, see