Hi there,
I'm trying to create a 3d model of a site in Australia. After running the AT i get a bunch of photos that just go off on a different plane and a corresponding section of points that run off with them. Has anyone seen this before? Does anyone know that the fix is?
This is typical broken model with multiple components. Do a camera precalibration so camera parameters are locked and it will at least drop photos which are not possible to tie instead of creating multiple models then it will be easier to add manual tie points. Either overlap was too small or the scene lacks details or there is repeating patterns in it.
Also could try tie point density: high and enable multi component run in aerotriangulation.
Hi Oto thanks for your response. To clarify what do you mean by camera calibration? On the Drone? Overlap was 80 /80 so would of through overlap is high enough? Its a sort of desert with red sand. Some buildings on it. Your thoughts?