Hi,
For a job I must generate a flat orthophoto generated from a film.
The film is about a concrete wall under water.
I've set the block type to "Vertical views only"
There are no servey points available.
After AT the result is not completely flat but curved.
Is there a way that the result can be drawn flat?
Regards,
Werner
You need to pre-calibrate camera, ideally using some swim around known object under-water. Under water introduces additional distortions so you may need to adjust settings and allow tangential distortion adjust.
https://communities.bentley.com/products/3d_imaging_and_point_cloud_software/w/wiki/28536/the-model-appears-to-be-curved-instead-of-being-horizontal-after-at