Thanks. One question. In update 19 not file preset "Do not use pose metadata for SfM". in Folder C:\Program Files\Bentley\ContextCapture\Presets\AT.  Problem with DJI p1 aerotriangulation. Not all foto calibrated. This problem was raised earlier in the forum https://communities.bentley.com/products/3d_imaging_and_point_cloud_software/f/contextcapture-descartes-pointools-forum/211116/dji-p1-smart-oblique-photo-not-calibrated.   Where to find this preset file?

Thanks. One question. In update 19 not file preset "Do not use pose metadata for SfM". in Folder C:\Program Files\Bentley\ContextCapture\Presets\AT.  Problem with DJI p1 aerotriangulation. Not all foto calibrated. This problem was raised earlier in the forum https://communities.bentley.com/products/3d_imaging_and_point_cloud_software/f/contextcapture-descartes-pointools-forum/211116/dji-p1-smart-oblique-photo-not-calibrated.   Where to find this preset file?

using DJI Zenmuse P1 in smart oblique mode

In latest version this preset is no longer needed. You could reuse it from older version if needed.

Also try legacy engine preset.

After triangulation, it turns out like this. Part of the photo flew upwards

Try to reuse calibration from 3D flight. It is also better to fly higher above forests. Upgrade DJI firmware as it seems Zenmuse is capturing part of UAV or you will have to add mask in left corner.

the latest firmware versions are installed