[EAP2] Profile Curve Between Elements tool question


As far as I remember, each vertical alignment in InRoads had to be defined in terms of curve type: either circular or parabola. In OpenRoads however, I've noticed that it's possible to have different types of curves in one alignment and I perceive this might leads to unwanted errors in VA design; that will result in a VA reports as shown below.

Hence, few questions:

1) Are there any plans to address this?

2) If not, can we have an option to define curve types that will prevent scenario I described above?

3) Also, when we're placing Vertical Curve, can we have information what parameter we're inputting - whether it's K value or Radii?



Parents Reply Children
No Data