Is there a tutorial or further information on how to use the "Flared Girder" option in Conspan? I am using version 14 and have entered the spacing between beams along the support but when the spacing is shown in the bridge section, the beam spacing is not correct.
Please email me your phone # at dilip.matange@bentley.com. I will call you to discuss. Regards Dilip
Is this the "Deck offset to Align" data listed in the bridge component layout? If so, those numbers match my Microstation sketches. I simply can't figure out what logic is used to define the girder locations. Their left hand reference seems to be a point out in space outside of the bridge deck and past the bent cap.
Furthermore, changing the spacing at the beginning of the girder also seems to change the location of the end of the girder.
When I go into the parametric editor to define the points manually, the bent stations have all changed.
Any ideas what is going on?
Issue might be related to alignment offset , please check that information.
I hope it helps
I am having a similar issue with a framing plan I am working on.
As you can see, I am ending up with girders outside of the bridge deck, and the girders do not appear to be spaced correctly. I have followed the advice above and cannot get the girders to the correct locations. Is this a graphical error, or do I have incorrect input?
The attached image should explain the Deck Offset and Deck Width along with other terms:
Regards
Dilip