Hi Diether. winzard ( Rm bridge) share files (gp, tcl) example precast girder . thanks

RE: Hi Diether. winzard ( Rm bridge) share files (gp, tcl) example precast girder . thanks

Zakaria Mohd Noor Arif — Fri, 28 Oct 2016 01:30:27 GMT

Thank you Marcos. That's very helpful. Really appreciate it.

RE: Hi Diether. winzard ( Rm bridge) share files (gp, tcl) example precast girder . thanks

MarcosBeier — Thu, 27 Oct 2016 16:56:15 GMT

Hi Zakaria Mohd Noor Arif,

Yes, you can create model with Wizzard and later edit them in Modeler if you use the option Detach, by right click at Wizard Object name. This will allow you to freely modify the geometrical model references. Just make sure to maintain coherence with all Analyzer data..

Thanks,

Marcos Beier

Senior Technical Support Engineer, Bridge

Bentley Systems Inc.

RE: Hi Diether. winzard ( Rm bridge) share files (gp, tcl) example precast girder . thanks

Zakaria Mohd Noor Arif — Thu, 27 Oct 2016 10:49:30 GMT

Hi Diether,

I've try using wizard, however when I try to edit the element in the modeler, The Wizard Windows Pop-up.

So the question is, can we manually edit the data in modeler (Axis, MG, Cross-section) after the wizard defined it?

RE: Hi Diether. winzard ( Rm bridge) share files (gp, tcl) example precast girder . thanks

Diether — Tue, 26 Jan 2016 13:33:55 GMT

Hi phu,
RM Bridge Wizards should be quite self-explanatory by just following the step-by-step input procedure over all the menus. You could even just open the Pre-cast Wizard, check the respective loads you want to consider in the menu "Load Definition" and click "Finsh" to get an example in GP/Modeler and RM/Analyzer.