OpenBridge haunch specification

Offline Koosh over 7 years ago

Is there a way to specify a haunch depth at the centerline of bearing, rather than an overall minimum haunch depth anywhere along the bridge in the OpenBridge software?

0 Offline Sri Thu, Oct 13 2016 2:00 PM
Minimum haunch is input per beam in OBM. OBM checks at several locations along the beam length to figure out where the minimum haunch falls. It is not possible to specify that the minimum haunch is to be checked only at the CL of bearing at each beam end. Please clarify use case, if this is something required in your state.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel