The problem of placing auxiliaries when use OBM

RE: The problem of placing auxiliaries when use OBM

ZeGan He 何则干 — Fri, 13 Dec 2019 02:37:58 GMT

Dear Sri

This issue persists in version 10.07.03.23. Is it a bug?

RE: The problem of placing auxiliaries when use OBM

ZeGan He 何则干 — Mon, 19 Jun 2017 02:27:54 GMT

AS seen in the picture below. In my case, I choose “select guideline provider” as the path selection mode, pick the P_1 as the guideline point of the inner side, pick the P_5 as the guideline point of the outside, set the start station with 5 and the end station with 18. You can see that both of the Auxiliaries of the inner side and outside are not in the right position at the end station 18.

communities.bentley.com/.../3.dgn

RE: The problem of placing auxiliaries when use OBM

Sri — Fri, 16 Jun 2017 15:12:35 GMT

ZeGan He, Not sure if I understood the problem correctly. But on the curved bridges, you could also use the "Guideline Provider" option rather than picking the alignment and specify the aux. along selected points on the template. Perhaps that would solve the issue.