In Leap Steel Bridge, after the analysis is ran I can not view support reactions for all of my abutments and piers. The only one that shows up is for the first abutment. I am unable to edit parameters like other result reports to view more POI's.
In addition (and most likely the same issue), when I am exporting to a substructure design, no loads transfer into the substructure model.
Thanks for the help!
I have a similar issue. I attempted to run the substructure module in LEAP Steel and also found that the reactions (dead and live) were either not coming through correctly into the substructure module and were still not correct when I tried generating them in the substructure module. Is there a reason that the reactions reported by LEAP Steel would be different then the reactions generated in the substructure module for the same model?
The reactions reported by LEAP Steel should be same as reactions generated in the substructure module for the same model.