Support Reactions not shown in Superstructure reports and substructure analysis - Leap Steel Bridge

RE: Support Reactions not shown in Superstructure reports and substructure analysis - Leap Steel Bridge

Mitch Magee — Wed, 23 Jan 2019 12:48:25 GMT

This solved my issue. Thanks!

RE: Support Reactions not shown in Superstructure reports and substructure analysis - Leap Steel Bridge

Vinay mysore — Wed, 23 Jan 2019 06:27:24 GMT

The reactions reported by LEAP Steel should be same as reactions generated in the substructure module for the same model.

RE: Support Reactions not shown in Superstructure reports and substructure analysis - Leap Steel Bridge

Timothy Aguilar — Tue, 22 Jan 2019 21:47:38 GMT

I have a similar issue. I attempted to run the substructure module in LEAP Steel and also found that the reactions (dead and live) were either not coming through correctly into the substructure module and were still not correct when I tried generating them in the substructure module. Is there a reason that the reactions reported by LEAP Steel would be different then the reactions generated in the substructure module for the same model?

RE: Support Reactions not shown in Superstructure reports and substructure analysis - Leap Steel Bridge

Vinay mysore — Mon, 21 Jan 2019 08:31:56 GMT

From the screenshot it looks like you are working on V18.00.00.31

The current release version iv V18.02.00.12.

Please download this version and check if the program is still not showing the support reactions in the output.

The POI are shown on the left hand side of the report. The user can choose.

Once the user runs the analysis then if the substructure module is opened the program will automatically generate the live loads on the supports.

The user does not have to generate the live loads.