RC Pier V19 -"Frame analysis failed -Frame model unstable" with hammerhead piers already designed in V18

I have updated to Leap Concrete V19 and I am getting a "Frame analysis failed -Frame model unstable" message for all my hammerhead piers that were already ran and designed.

Has someone else reported this? Could you look into this?

Thanks.

Parents

0 Offline Louie Husseini Fri, Apr 26 2019 8:29 AM

Same on a cap & column model designed in V18
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Offline Vinay mysore Fri, Apr 26 2019 8:39 AM in reply to Louie Husseini
We are looking into this issue and we will get back to you at the earliest.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Offline Vinay mysore Fri, Apr 26 2019 9:45 AM in reply to Vinay mysore
Also please delete the LEAP folder from the %temp% folder using the below shown steps and try:

Exit all LEAP sessions you may have open on the machine.

Open File Explorer and type “%temp%” and click on Enter:

This will open the temp location for your login

In this folder delete “LEAP_BAK” and LEAPBridgeConcrete” folders

Open LBC and try again.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Reject Answer

Cancel
0 Offline Joe Thu, May 28 2020 9:01 AM in reply to Vinay mysore

Is there an update on this issue? I have the same problem for a pile cap model. My model was done from scratch in CE V19.02.00.33

I followed the steps above to delete “LEAP_BAK” and "LEAPBridgeConcrete” folders but that did not help.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Offline Joe Thu, May 28 2020 9:01 AM in reply to Vinay mysore

Is there an update on this issue? I have the same problem for a pile cap model. My model was done from scratch in CE V19.02.00.33

I followed the steps above to delete “LEAP_BAK” and "LEAPBridgeConcrete” folders but that did not help.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data