A few questions:
I created a three span PS Bulb-Tee bridge model from Open Bridge Designer, got superstructure designed, now getting into substructure design, here are a few questions (also see attached file for more clarity of the snap shots)
1. First I choose Abutment -> click Abutment Config., when I click OK without even changing anything, there is a warning message "Input value must be greater than -0"; after I changed some of the numbers, similar messages will pop up. Basically I can not edit anything. Is this supposed to be? Similarly if I want to check superstructure, etc.
2. Second question - I can Generate DC, but can't Generate LL + IM. After click Edit to LL1, button Generate is grayed out, why? However, it seems I can generate Permit Live Load LLp, a strange thing is that not only permit live load, all the design live loads are shown in LLp, which is fine since I can select the permit load.
DOCX
Going thru the attached word document: