No active profile when trying to add bridge

Question

I am trying to Add a bridge to an alignment but the alignment says "No Active Profile" when I try to click on it. My road designer made an alignment and linked the profile. Am I having a compatibility issue? I have OpenBridge Modeler version 10.06.00.41 and the alignments were made in MicroStation SS4 8.11.09.838 & InRoads SS4 8.11.09.903

Vlad Grigoras · Accepted Answer

Most likely you did not assign the profile as the active profile for the selected alignment. 
 
 If assigning the active profile does not work for you, please send me the file at vlad.grigoras@bentley.com and I will have a look at it.

Marcelo F. DaSilva · Answer

I have had the same issue and for me it was compatabiility issue. I had created the alignment using geopak (v8i series 10) but openbridge version is the Connect edition (10.04.00.747). 
 
 Once I created the alignment using ORD (CE). Problem was solved.

MarcosBeier · Answer

Verify that the Profile set as Active is defined for the selected Alignment and stationing and not somewhere else