When checking Show P-delta Effects in the Analysis tab, are the values shown represent values with p-delta effect? For example, are the column/shaft moments magnified with p-delta factor in these load combinations (with a "C" on the end of the LC#)? If yes, they should match the values in the Column tab Design Statuses, right? If not, what values are these?
If none of the above correct, can you suggest how to extract p-delta factors for each column. I'm trying to extract P-delta factors at my top of shafts, but I'm getting 3 different values per shaft for my Mx and Mz for one Load Combination that's showed as the one causing the worst loading.
Edit: Quick investigation into the load combinations with the "C" showed that the LC# shown on the Column Design Statuses is wrong. I was able to find the values under a different Load Combination number. Is this a known glitch?