I need to vary the width of the top flange of a Super-T girder (Australian) to follow the curved edge of a bridge deck. I can add variables to the points on the beam template but can't see how to access them/set them when the beam is used in a beam group (or anywhere). Is this possible in OpenBridge Modeler?
Thanks Vlad,
Thanks for your reply. Yes, I did eventually find that. Do you know if the ability to add variables to beam templates actually has any benefit. Is there a way to vary other beam points based on targets?
Hi David,
Using the custom templates you can vary across different cross-sections along a beam length. You can find more information about this in the bellow post.
How to use wet joints (closure pours) between concrete beams - LARS | LEAP | OpenBridge | RM Wiki - LARS | LEAP | OpenBridge | RM - Bentley Communities
The more I investigate this the more I'm learning about the capabilities of OpenBridge. All good stuff!