I have a double bearing line on my bent cap design in RC Pier. When I check to view my loads on my model, the loads are only being applied to one bearing line. I want them applied to both, is there a setting I am missing to have my loads apply to both bearing lines? I have attached a screenshot of a wind load case on my model to show how it is only on one bearing line. I am autogenerating my wind loads. I have done this before and it applies to both bearing line, so I am wondering if there is a setting that might've got turned off or something! Thanks in advance
There will be symmetrical Dead Load and Wind load getting applied on the other bearing line.
Program will try to create the worst case scenario.
If you want to Customize some bearing loads then you can apply the DL and WL bearing values manually as well,