Custom barrier using PLACE PATH

Question

Hi, 
 
 I'm new on using OpenBridgeModeller. I'm trying to place a custom barrier by using PLACE PATH. I created the custom barrier in the AuxLib.cel. Its showing on the list (see image below), but when I try placing it, its not appearing on the model. Hope anyone can help me with this. P.S. I'm not using the PLACE BARRIER command because I'm trying to create the barrier layout per specific length. Using the PLACE BARRIER make the barriers all through out the bridge without any joints/gap.

Sri · Accepted Answer

You can use the PLACE PATH to place a series of barrier cells. Simply specify the spacing (typically the length of the cell unit) and they will be added. If you are not able to place the specific cell you created, can you check the one above "Barrier_HandRail" from your list. This is the cell I tried.

Custom barrier using PLACE PATH

Top Replies