The cross section is a rectangle. Its height is associated with a variable H.
I created a table htab1, the shape of it is like this
I created 2 segments:
Segment1 use link segment, and its vartiable H was associated with htab1;
Segment2 use regular segment, and its vartiable H was associated with htab1 too.
The resulting model of Segment1 has steped shape， which is wrong
while the resulting model of Segment2 has smoothed shape, which is correct
The TCL is attached: 4863.gp9.zip
In Segment 1 with link elements try to use 0.0, 0.5, 1.0 for the x-axis.
For more information about RMv11.13, please look at the below link:
Ana Carla Peres
Senior Technical Support Engineer
Answer Verified By: MarcosBeier
Where can I input "0.0, 0.5, 1.0 for the x-axis", I tried to input them in htab1, but it doesn't work
BTW: The TCL is attached in the top thread
Hi, It should be necessary to divide the link element too, as link elements can assign only cross-sections at the connections, begin and end of the element.
I can look at your file, but I need to create one service for answering you, Can you send me your email address please to firstname.lastname@example.org. Thank you.
The full TCL is attached.
I'm going to investigate your file and come back to you through SR 7001409176.
Has this issue been fixed in 2022 R1?
Is in our Backlog List. Defect n.882558
For RMv11.14, you can look at the new implementations here:
Thank you, unfortunately it couldn't been found in the list.