Send Open Bridge model to RM-Bridge for analysis later

Question

Hi, 
 I modeled my bridge (a skewed slab bridge with its supports and bearings) with OBM and then tried to send it to RM-Bridge (in Open Bridge Designer), 
 but the software did not allow it (see attached captures). 
 Is it because of the type of piers or abutments I used or else? 
 Thanks.

Ana Carla Peres · Accepted Answer

Hi Kamel, Thanks for the files. 
 One solution can be to generate one second axis throughout the bridge structure, due to the wide eccentricity of the road alignment. 
 
 After send this model to RM Bridge: 
 
 Due to the high skew angles, it may be necessary to check bearings position and deck CS properties and adjust them in RM Bridge, if it is the case. 
 Best Regards, 
 Ana Carla

Ana Carla Peres · Answer

Hi Kamel, if it is a slab bridge it should be possible. Could you please send me the OBM *.dgn file to anacarla.peres@bentley.com. 
 Best Regards,

Send Open Bridge model to RM-Bridge for analysis later

Top Replies