The bridge I am working on has 4 splice locations at each member. For some reason, after running an analysis, the first and last field splice do not appear to be updated and the program is still prompting me to run an analysis at those locations before I can design the splice. I've tried running FEM, Grillage, and Line Girder, but still get the same result. I even tried deleting out all the section breaks in the member definition and adding them back in to make sure there weren't any rounding errors, but the issue still occurred.
The only thing I have seen that is different about these 2 locations is they are also defined as a "mid-bracing point" within Point of Interest Locations dialog. I'm thinking this may be what is causing the issue during analysis as I tried adding a splice at another arbitrary mid-brace point and the same issue was happening there as well. I am not sure why this would be preventing the analysis to run and I haven't been able to find a way to un-assign a mid brace point.
Is there a valid reason I am not able to add splices at these points?
See below for screenshots.