How is the value "Offset between center of the deck and center of the bent cap" measured? Is it along the cap? How would it be determined for a skewed cap?

Recently, I have started working on Leap Bridge Concrete V 17.01.01.11 , and we start questioning whether the hanger reinforcement check has been considered or not on this version, AASHTO 5.13.2.5.5. I couldn't see anywhere checking the combination of…

I am designing a 2-span precast prestressed beam bridge in LEAP Bridge Concrete CONNECT Edition v17.00.01.01. The bearing dimensions along the pier cap are shown correctly in the following view under the 'Substructure' tab: However, when you click…

Is it possible to model an open joint in a pier cap in RC-Pier? See image below. If not what would be the best work around? I'm using RC-Pier V8i (SELECTseries 6), Version 13.00.00.68.

Is it possible to design Post tension bents through RM Bridge. If it is possible can design the anchor zone reinforcement through it