• Longitudinal Section in OpenBridge Connect version. Is it possible to follow the alignment of the bridge?

    Hello to everyone, I would like to know if someone knows if it is possible to create a longitudinal section of a bridge along its alignment so that if the bridge is in horizontal curve I can get the real longitudinal profile? Perhaps it is possible…

  • "Roadway limit is breached"

    Im in LEAP Steel and have started a model all the way up to entering the supports. I click ok and get error message "Roadway limit is breached". All my supports are within my begin and end station, I am doing the same as I have with successful models…

  • OpenBridge - How to update an existing Alignment

    My situation is that I have an alignment sent to me as an alg file, which I have imported into OpenBridge and have used to make bridges. I have received another alg file which contains updates to the current alignment. Whenever I try to import this new…

  • OpenBridge Deck Slab - Keeping Soffit of Deck Slab horizontal (not following vertical curvature of the alignment)

    Is there any way to allow the Top face of the slab to follow the curvature of the alignment (horizontal and vertical), but for the Soffit of the slab to remain level (horizontal, but vertical is fixed). Or for the slab to be placed to follow the horizontal…

  • [OBM SS3 MR1] changing bridge alignment

    Hi, I'm trying to change bridge alignment so as bridge model sits on new alignment option. The current bridge is located around station 7000 but changing alignment results in bridge shifted to station 0. Looks like pier lines don't preserve station information…

  • What is the best way for both OpenRoads and OpenBridge modelers to work from the same alignment?

    Is it possible for both to reference in a single alignment file (stored on projectwise), thus changes to that alignment file would result in updated OpenRoad and OpenBridge Models?

  • RE: Open Bridge Modeler - vary deck slab linearly on a curve alignment

    Mike, You should be able to draw an alignment line (a simple chord) in the DGN, and set the deck - Point Constraints, to follow this line. Thanks, Sri

  • OpenBridge haunch specification

    Is there a way to specify a haunch depth at the centerline of bearing, rather than an overall minimum haunch depth anywhere along the bridge in the OpenBridge software?

  • Is it possible to design multi-cell box culverts in OpenBridge?

    I'm new to the software and curious to its limitations.
Communities
Support and Services
Training and Learning
Social Media