• RCPier P-Delta Analysis increases axial forces in the column.

    When running analysis with and without P-delta I noticed there is a substantial increase in the axial column force when P-delta is applied. At the node 1 the difference is about 300 kips. What could be a reason for such an increase? Any insight is appreciated…
  • LEAP Bridge - RCPier Centrifugal Forces Considerations

    Hi, There are cases where centrifugal forces produce a moment that actually counteracts the critical moment in the column, does RCPier consider effects due to vehicle cases without centrifugal forces as provisioned in AASHTO Spec (See below excerpt…
  • LEAP RC-PIER P-delta effect in load combinations

    When checking Show P-delta Effects in the Analysis tab, are the values shown represent values with p-delta effect? For example, are the column/shaft moments magnified with p-delta factor in these load combinations (with a "C" on the end of the LC#)? If…
  • RCPier crashes on open

    I am using Leap Bridge Enterprise v14.00.00.09 in a Win7 environment. When I open the Geomath and Conspan modules, they work fine. When I open RCPier, it gets to a screen which says "Loading Project File" and then crashes, and it sometimes gives me a…
  • New Release: LEAP Bridge V8i(SELECTseries 1) v9.0.0

    Release 9.0.0 of the LEAP Bridge Suite is scheduled to be released June 25, 2009. Several outstanding features are included in this release. Here is a brief list of some of the new features for this version : LEAP Bridge v 9.0.0 incorporates the…
  • LEAP Bridge V8i Release Enhancements

    LEAP Bridge v8.1.0 incorporates the following enhancements: • The ABC Wizard can now directly read in alignment, cross-section and profile information from LandXML files. The bridge model can now be generated very accurately directly utilizing…
  • RC-Pier: Best way to input vertical wind loads on pier.

    I'm trying to apply vertical wind loads on a pier per AASHTO LRFD 3.8.2. The problem I have is with the load combination generation. This load shoud only be applied during Strength III and Service IV limit states. Is there a way to specify this for the…
  • LEAP bridge problems

    Hello all: I am having an extremely difficult time getting through my bridge design on LEAP bridge. Especially while working in GEOMATH and RC PIER. In GEOMATH: Problem #1: Back when I was trying to make minor adjustments to the geometry of the…